HELPFUL TIPS TO WASH THE EXTERIOR
-
Wash the car in a shaded area and never in direct sunlight, to prevent the shampoo from drying out, which will stain.
-
If the car has been exposed to the sun or the bonnet is very hot, cool the surface with a jet of cold water.
-
It is the least dirty part and you will avoid dirtying the glove: washing will be faster.
-
In the first you will put the solution of water and shampoo, in the second only water to rinse frequently the sponge or glove: you will avoid scratching the bodywork.
-
You will not forget any part, the product will be very effective and will not dry: you will prevent stains and marks.
-
Clean the rims with a brush that can reach the most hidden points.
To use the product you will need:
For the application of the product
Clean and dry for finishing
To remove stubborn limescale stains or in hard-to-reach places
Waterspot Mineral Remover is perfect for removing mineral contamination caused by highly sedimented limestone that can no longer be removed with a classic washing cycle consisting of pre-wash and wash with neutral or alkaline shampoo.
Before using this product, we advise you to proceed with a thorough washing, according to the correct washing sequence: rims and tires, pre-wash and manual washing with shampoo.
If at the end of drying there remain: limescale stains, strongly anchored mineral residues or halos on the crystals, Waterspot Mineral Remover is perfect for removing these sedimented contaminations.
Having carried out a complete washing, it will be easier to identify all the points where the contamination is concentrated and to act in a localized way with the most suitable technique.
Proceed by dispensing the product on a moistened microfiber pad and gently massage the surface working the product. Finally, proceed with finishing with a damp microfiber cloth.
For a better rinse in total safety, you can use the Exterior Quick Detailer.
You can learn more about its use in its dedicated video.
If the limescale stains are extensive, use Waterspot Mineral Remover during the washing process, with the car wet, then proceed with rinsing and drying.
Its formula is effective and safe on all surfaces, and, for its processing we can also help with a soft bristle brush, useful for reaching delicate, difficult to access points or for working during the phase of removing limestone from glass. plastics, emblems, logos and moldings.
Always proceed one panel at a time, or work small areas without ever letting the product dry.
HELPFUL TIPS TO WASH THE EXTERIOR
-
Wash the car in a shaded area and never in direct sunlight, to prevent the shampoo from drying out, which will stain.
-
If the car has been exposed to the sun or the bonnet is very hot, cool the surface with a jet of cold water.
-
It is the least dirty part and you will avoid dirtying the glove: washing will be faster.
-
In the first you will put the solution of water and shampoo, in the second only water to rinse frequently the sponge or glove: you will avoid scratching the bodywork.
-
You will not forget any part, the product will be very effective and will not dry: you will prevent stains and marks.
-
Clean the rims with a brush that can reach the most hidden points.
Why is it important to remove limescale from the surface?
Because it would dull the colour and penetrate the clear coat on the body of the car, deeply staining it. It would also stain the windows and prevent good visibility.
Should Water Spot Remover be used on wet or dry cars?
It depends: on dry surfaces when localised contamination is present. On wet cars when widespread and large contamination is present or on the windows.
If the car is completely contaminated by limescale, what should I do?
First do a thorough wash with the Foam Gun Prewash or with the Black&Wrap Shampoo for black or wrapped cars. If required, spray Water Spot Mineral Remover onto the washing mitt and wipe it over the bodywork.
